Doepfer A-190-8

Needed to sync my modular with the DAW. I avoided midi for several years, recording/adjusting clock signals directly and routing the tracks into clock inputs. However after a while this got old, so I got myself this. I don't use the divider outputs, as I have enough dividers. Also I never needed the "run" gate, until last week, when I was playing with a friend whose main clock is mn tempi and the gate came really handy for start/stop.

If your needs are modest and just need a clock from MIDI, then this is the baby. Reasonably priced, quality build. By the company that started it all. Get a rack full of their stuff and you will laugh at others who have 'esoteric' modules that are hard to use but have a different paint job. Highly recommend everything by this company.

Simple module - with a MIDI cable in, you can sync the eurorack clock to your MIDI gear. If you want the ability to do this, this is the module. I haven't used the USB, so can't comment on that.
Sometimes the clock glitches out slightly; I don't know if that's an issue with MIDI, the module or my sequencer but it's not too much of an issue.

Been wanting this for a long time, I use it to hook up E-RM Midi Clock so I can finally run A155 in sync to a master clock
Works perfect with no issues, although I find the A154 Controller can be a bit temperamental when overriding Stop/Start with the A190-8, no issues running direct into A155.
Other than that I can't fault this very useful module.

very good product as usual with Doepfer.

It converts midi clock signal to trigger signals.

it's also a clock multiplier!

I use it in my modular with two "multiples", three "ADSR", a "clock diviser", and a sequencer.

Do not hesitate!!