La conținutul paginii

3 - Pole Angle Jack Plug 6.3 mm

  • Gold-plated contacts
  • Black shell
  • disponibil din Februarie 2007
  • numărul articolului 108378
  • unitate de vânzare 1 bucată(ăţi)
  • Installation No
  • Mono/Stereo Stereo
  • Angled Yes
  • Type TRS (stereo/sym.)
  • Plug Jack 6,3 mm TRS male angled
39 lei
Toate prețurile includ TVA
în stoc
1

406 Evaluările clienților

4.9 / 5

Măiestrie

137 Recenzii

a
Calitate
alexino 25.02.2023
Neutrik este un producator foarte bun de mufe si folosesc multe dintre produsele lor, sunt foarte multumit.
Măiestrie
0
0
semnaleaza un abuz

semnaleaza un abuz

b
babustyle 18.10.2024
Foarte bun ,ideal pentru caburile de iesire din clapa gen Korg pa 4,pa5,Yamaha si toate clapele ce au iesire balansata
Măiestrie
0
0
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
b
Replacement for earphones
busy_b 06.02.2020
I was bothered with the straight connector of my headphones sticking out of soundcard ready to be broken away by any careless move and cable at right angle prone to breakage. So I've bought this Neutrik NP3, my friend electrician helped me to replace the connector and I have much safer connection now. The jack fits better and in my opinion the sound is better, too. It was worth the effort.
Măiestrie
0
0
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
aT
Works great with sample pads
a Tamás 30.05.2026
Pros
Any device with lots of TRS inputs and outputs on its back laid out horizontally, such as drum modules and sample pads, will benefit from using angled connectors like this. Cables are nicely hidden, don't get struck, bent or pulled out as easily as straight ones.
I have paired this connector with the BPX-L large chuck and boot and used it on a 7.6mm diameter cable. It somehow works better with a large cable size than the slimmer straight connector NP3 X-B does.
Cons
The tip and ring pins are quite close to each other and there is a piece of plastic separating them, so one has to be careful not to melt that.
The 2 parts of the shell may slide apart and create a gap as you tighten the boot unless you hold them together tightly. Even if done properly there still is a small gap between the 2 parts of the shell where water or vapor may enter.
Măiestrie
0
0
semnaleaza un abuz

semnaleaza un abuz