Thomann SK140 Jack mono Angled

()

Start 360°

Arată traducerea

6.3 mm Mono Jack Angle Connector

Maximum cable diameter: 7.14 mm
Metal connector
High quality

Garantarea rambursării banilor în 30 de zile

3-Ani Garanţie Thomann

disponibil din Mai 2000
numărul articolului 128508
unitate de vânzare 1 bucată(ăţi)
Installation No
Mono/Stereo Mono
Angled Yes
Type TS (mono/unsym.)
Plug Jack 6,3 mm TS male angled

Variante produs

1047

Thomann SK140 Jack mono Angled

Thomann SK140 Jack mono Angled 6.3 mm Mono Jack Angle Connector * Maximum cable diameter: 7.14 mm * Metal connector * Hi...

5,30 lei

pagina produsului

551

Thomann SK129 Jack stereo

Thomann SK129 Jack stereo 6.3 mm Jack Stereo Plug * Balanced * Max. cable diameter: 7.14 mm * Metal connector * High qua...

4,18 lei

pagina produsului

670

Thomann SK128 Jack mono

Thomann SK128 Jack mono 6.3 mm Mono Jack Plug * Max. cable diameter: 7.14 mm * Metal connector * High quality finish * W...

3,66 lei

pagina produsului

273

Thomann SK096 female Jack

Thomann SK096 female Jack Coupling jack, female * Usable in stereo and mono mode * Metal housing * Kink protection * 6.3...

7,90 lei

pagina produsului

5,30 lei

Toate prețurile includ TVA

Reduceri pe volum

Preț pe bucată	Veți economisi	Cantitate
5,30 lei		1
5,09 lei	4,0%	10
4,69 lei	11,5%	50

Nivel de vânzări

în Jack-uri (6,3mm)

Asta au cumpărat clienții care au văzut acest produs

Thomann SK128 Jack mono

1047 Evaluările clienților

5 660 Clienți 4 283 Clienți 3 85 Clienți 2 10 Clienți 1 9 Clienți

4.5 / 5

Măiestrie

Recenzii ghiduri

426 Recenzii

Arată traducerea

Arată originalul

Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.

Thomann SK140 Jack mono Angled

WD555 30.04.2017

Thomann SK140 Jack mono Angled
I have used these Thomann mono angled jacks many times before and they are in my opinion the best value in angled jacks.
Much cheaper than the big brand name jacks and really very good quailty for the price paid.
The metal outer casing is robust and I have never had any damage to them.
The outer casing screws over the inner part and the threads are well cut without any rough edges - the two parts do unscrew quite easily and I have taken to adding a little locktite thread locker o these threads to stop them from unscrewing in use but obviously only after I have tested the final cable is working !!!
Inside the outer cover is a thin plastic sleeve which slides over the connection to prevent the inner core terminal shorting to the ground cover.
The terminals are easily soldered and the outer clamp is easy to form with a crimping tool or carefully with needle nose pliers.
I add 75mm of heatshrink tubing to cover the side joint, again only after the vale has been tested, this protects the joints and also adds some protection in the form of relieving cable strain where the cable enters the housing, this technique is used on the "pro snake" cables which I believe also use the same angled mono jack plugs.
If you are using these jacks to make patch cables for a pedal board and want the angled jacks to be as close as possible (together, back to back ) then two jacks will require approximately 32mm space between pedals.

semnaleaza un abuz

Consideraţi această evaluare inexacă sau inacceptabilă din anumite motive? Vă rugăm indicaţi motivul părerii dvs în următorul câmp – dacă e posibil – adresa de e-mail pentru întrebări suplimentare.

Arată traducerea

Arată originalul

Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.

Excellent price?performance ratio

Anonim 11.02.2017

Feedback for "Thomann SK140 jack mono angled"
A very cheap angled jack but do not let the low price fool you, it's a very decent little jack indeed.
These are the same jacks that are used on the "Pro Snake Patch - Professional Angled Jack Patch Cables".
All metal housing, they are not the prettiest jacks but quite solid and built to last.
I use the Pro Snake Patch leads on my pedal board but needed some longer leads to run from the board to my amps.
I have been experimenting with double, triple and even quad amp rigs recently and needed some extra cables but wanted to keep the cable runs to an absolute minimum so I cut up some old whirlwind cables that were far too long and was able to make them the exact length then used these angled jacks to complete the job.
The angled jack is great with pedals as it greatly reduces the space needed on pedal boards but I like to use the angled jacks going into my amps as it reduces the strain on the input sockets.
They are very easy to use and I will be ordering more soon to shorten cable runs and tidy my pedal board as soon as I have it completed.
So far I haven't had any problems with them, the only minor complaint is that the outer cover comes loose quite easily, it's no great problem but I think I will try a little low strength thread lock just to keep them from coming loose.

semnaleaza un abuz

Arată traducerea

Arată originalul

Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.

Great alternative!

Mofosir 23.01.2022

Bought a bunch of these for patch cables, seemed decent enought from the photos, so what the heck. They are better than I thought they were going to be, the metal is thick and sturdy, the thread is good and solid, but best of all are the soldering contacts - they're very well laid out, in a way where you really don't need to worry about jumping the contacts, also the metal itself takes well to solder AND they take a pretty thick cable! Only somewhat negative with these jacks is the fact that they unscrew easily, which can be a bit annoying, but as with all jacks, I just put some plumber's tape on the thread and it stops it from unscrewing forever. Definitely would recommend, rock solid jacks.

semnaleaza un abuz

Arată traducerea

Arată originalul

Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.

Solid Quality Plug

Anonim 06.05.2015

You will be surprised with the quality of this plug.
I can only confirm the positive reviews of this product.

It's a very basic and straightforward plug made out of cast metal.
It comes with a short strip of transparent tube to isolate the soldering points.
It DOES have an internal metal chord grip which has to be tightened with a pair of pliers, but it does hold the cable in place nice and tight. The bottom piece leaves a bit room around even the thickest cables, but it's still secured through the internal chord grip.

It's a very sturdy and noise free plug, which I have used in combination with the Sommer Cable The Spirit to solder all of my patch cables and even some instrument cables. They have survived this far and show no signs of coming loose or breaking.

If you want to upgrade from your cheap molded patch cables, these will be more than enough.

semnaleaza un abuz

Citește toate recenziile

Thomann SK140 Jack mono Angled

6.3 mm Mono Jack Angle Connector

Asta au cumpărat clienții care au văzut acest produs

1047 Evaluările clienților

Pentru a evalua produse trebuie să fiţi logat.

426 Recenzii

smart navigator

Servit cu dragoste!

Thomann SK140 Jack mono Angled

6.3 mm Mono Jack Angle Connector

Asta au cumpărat clienții care au văzut acest produs

Accesorii și articole compatibile

1047 Evaluările clienților

Pentru a evalua produse trebuie să fiţi logat.

426 Recenzii

Compară opțiunile

smart navigator