Kluson MLS33C Lockheads

()

Start 360°

Arată traducerea

Locking Machine Head Set for Electric and Acoustic Guitar

Style: 3 Left / 3 right
Closed construction
Buttons: Metal style
Gear ratio: 1:18
Bore: 10 mm
Screw tab: 45°
Fasten via screws and counter bearing (included)
Finish: Chrome

Garantarea rambursării banilor în 30 de zile

3-Ani Garanţie Thomann

disponibil din Februarie 2010
numărul articolului 241722
unitate de vânzare 1 bucată(ăţi)
Colour Chrome
Locking No
Design Modern

258 lei

Toate prețurile includ TVA

199

Nivel de vânzări

în Cheiţe de Chitară 3S/3D

225 Evaluările clienților

5 176 Clienți 4 35 Clienți 3 9 Clienți 2 3 Clienți 1 2 Clienți

4.7 / 5

Măiestrie

Recenzii ghiduri

129 Recenzii

Arată traducerea

Arată originalul

Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.

Tasos N 21.04.2018

Perfect replacement for a PRS SE. Unfortunately the fact that you need a screwdriver to lock the string has two issues: 1) You have to carry a screwdriver with you 2) You can't really tell if the string is as tight as it should and there is always a possibility to overtighten the screw and break the string as soon as you put enough tension to it. I also think that the edges of the wholes where the string gets in are a bit sharp, which might also cause the string to break.

semnaleaza un abuz

Consideraţi această evaluare inexacă sau inacceptabilă din anumite motive? Vă rugăm indicaţi motivul părerii dvs în următorul câmp – dacă e posibil – adresa de e-mail pentru întrebări suplimentare.

Arată traducerea

Arată originalul

Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.

Kluson for the win

NevermindMe 08.09.2022

I bought a set of these to replace the stock tuners on my Fender CD-60S acoustic guitar. The stock tuners worked just fine, but after 3 years one of them started skipping, so the D string was either a bit sharp or a bit flat. Happy to say that they fit without redrilling, the screws are identical in size and the screw hole was off by less than 1/2 mm, so it worked just fine.
A word of caution when tightening the locking section: first tighten the screw over the string with just your hand, which is enough to hold the loose string. Then use a thin coin (2 euro cents) or screwdriver for just another 1/4 turn; a 1/2 turn broke my new G string the first time I was installing strings. I have since found that tightening them with just the fingers is fine, too. The thing I like the most is they have very low posts, so no need to wind the string down, there is great break angle over the nut. Just lock it and tune up. For those that like to wind it, there is little space, maybe 1.5 turns on the thicker strings. To be able to have enough room to get a string in safely after installing the tuners, the headstock should not be thicker than 16mm. The caliper says you should be able to use a maximum 0.065 string size, but I was easily able to fit a 0.074 from an 8-string set.

semnaleaza un abuz

Arată traducerea

Arată originalul

Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.

An upgrade for my Höfner Shorty

Archion 25.09.2021

Bought them as an upgrade for my Höfner Shorty travel guitar. As the original tuners were a bit lumpy I thought if I'm already going to replace the tuners, why not get a locking ones. So far they've been working very well. The only thing is that I'm much more used to locking the tuners with a so called wheel below the tuner. With these there's a thumbscrew above the tuner, which may feel a bit awkward at first. Once you'll get used to it, it works like a charm.

semnaleaza un abuz

Arată traducerea

Arată originalul

Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.

Shaft length 20mm

TeeFon 13.10.2020

These machine heads are high quality. They feel sturdy and durable. I am sure they would have been a great upgrade for my newly acquired HB CST24, however shaft length is too short for the CST24. I was really gutted cause I really wanted to install them.

Only con for me (and why the 4*) is the lack of info on specs incl shaft length which i didn't know was going to be an issue.

semnaleaza un abuz

Citește toate recenziile

Kluson MLS33C Lockheads

Locking Machine Head Set for Electric and Acoustic Guitar

225 Evaluările clienților

Pentru a evalua produse trebuie să fiţi logat.

129 Recenzii

smart navigator

Servit cu dragoste!

Kluson MLS33C Lockheads

Locking Machine Head Set for Electric and Acoustic Guitar

Accesorii și articole compatibile

225 Evaluările clienților

Pentru a evalua produse trebuie să fiţi logat.

129 Recenzii

Compară opțiunile

smart navigator